Geothermal and Bamboo flooring, solid wood flooring is "not a tune"

"Solid wood flooring can be used for geothermal?" and "bamboo floor heat deformation?" and "floor so thick thermal energy?" and "too hot, the floor does not drum for a minute?" more and more popular geothermal heating, use of geothermal heating optional floor must "remedy", material, thickness, pavement, cushion, and said that a lot.

With "geothermal heating" on the floor of the many requirements, 29, reporters interviewed sales floor 10 years of Ms. Xiao to Ying. Shaw to Ying the floor radiant heating floor standard "has been introduced, standard on the warm heat source, floor pavement and product selection all the appropriate provisions. Geothermal floor can choose flooring and solid wood flooring much, Bamboo flooring and solid wood flooring is not suitable for geothermal heating.

Bamboo flooring and solid wood flooring-resisting easy deformation

Geothermal floor are laminated flooring and solid wood for multilayer parquet flooring and purification of the geothermal bamboo wood floor cannot be "competent" this "job".

Size from deformation, ordinary Bamboo flooring deformation quantity is smaller than the solid wood flooring, but much larger than the flooring and solid wood flooring much, so the use of geothermal energy, environment, there are certain common bamboo floor.

If pure wood flooring for floor geothermal environments, one at a time as possible, prevent floor repeated installation process leading to the floor the latch closed coating damage to floor with air humidity deformation. In addition, installing the front to check whether the smooth surface, such as the sand of the outer convex to dispose of sand, prevent causing moisture-proof coating and floor moisture-proof coating damage.

12mm ~ 15mm thickness of heat conductivity is best

In General, the smaller the thickness of the floor, the greater the heat flow. The larger the floor thickness on thermal transmission does have a certain impact, but the effect is not a "great". But it is best to choose a thickness to 15mm 12mm, by comparison, the thickness of the floor than 12mm 15mm thermal soon, but in continuous heating environment, both thermal difference is not obvious; floor feet thick point better, costs are higher. For continuous heating, if the heating system can ensure that it reaches room temperature of basic requirements, you can select a bit thick floor.

In addition, geothermal, floor temperature of relatively high, with the temperature, the floor of formaldehyde release faster, so you should try to select the formaldehyde emission low floor.

As geothermal floor, it is best not to select too wide or too long for the floor, the larger the size of the floor, in geothermal crevice of the environment. Especially the wide surface of one piece parquet, if its surface moisture content should be controlled at 8%, otherwise the floor surface cracking. In geothermal conditions also have a cracking. Therefore, as the geothermal use parquet in production, to strictly control the surface of the water content.

In geothermal conditions, when the floor moisture content is changed, the strip of expansion, flooring Board appears obvious rib shaped corrugation. If the parquet surface thickness above the 3mm is less prone to the phenomenon. Therefore, the layer thickness and following 3mm parquet is not suitable as a geothermal floor and 7-layer hardwood flooring comparison ~ 11 for geothermal heating.

Mat selection tinfoil better

Mat selection tinfoil, heat evenly. If pad is too thick, will result in the floor up, causing the latch mutual friction, easy to produce sound, but also prevents thermal volatilization. Also, select the 2 mm of ordinary plastic mats can either play the role of buffer damping, can also be a good moisture barrier.