In-depth analysis of floor heating two errors in the heating installation in mind trap

Floor heating is commonly known as "hot", the heat from the ground up is distributed in the form of heating. As geothermal heating way ergonomic, and affordable favored in recent years.

However, despite the geothermal heating set away advantages, but as a special type of heating, consumption, installation and use of process, inevitably there are some confusing errors and "knowledge" the blind spot. Therefore, in the geothermal "please" into the door, let's do a simple understanding of it.

Floor heating errors

All buildings are a mistake can be put

Floor heating system is not available for all buildings, the current installation, adaptation has wide blindness and follow the trend. According to a source of decoration company introduction project manager Liu Fei, at present, the main form of the geothermal heating system has two types of geothermal heating, soon-to-metal tube, pipe, etc. into concrete floor in coal, oil, gas boilers or electric boiler to provide hot water heating, electric geothermal heating, heating cable buried in concrete floors, rely on 220V electricity to direct heating or heating.

Theoretically, this way of heating, hot air from the bottom up, foot hot body heat. But for residential, geothermal only applies to the bathroom and kitchen, bedroom, living room, because the library has a lot of furniture, furniture on the one hand, geothermic heat powder out obstacles, on the other hand, higher surface temperature will make furniture deformation, damaged.

In addition, installing geothermal heating must be in the cable laying of concrete/cement layer (direct heating 3-5cm, regenerative 5-8cm), thereby greatly increasing the load on the floor. Therefore, installing geothermal heating of buildings must be in the building structure design stage for special prices, to increase the structural strength.

And now some developers do not consider this issue, if the construction quality does not cross the border to whole building buried under a security risk.

Myth II applies all plate

Geothermal heating the ground cannot shop purchase solid wood flooring, because the installation of concrete nail keel can damage the pipe or cable. Shop Home flooring also has a big problem, as we all know, reset the parquet laying a layer below must foam layer, but the foam layer is insulation material, will seriously impede the heat powder out, if you don't shop foam layer, the service life of composite floor will be greatly affected.

Many businesses have claimed that the floor can be used for geothermal heating system, this is actually a misleading consumers. Liu Fei, the vast majority of the floors on the market today such as 12-18mm thick solid wood flooring, Bamboo flooring, and so on, are not suitable for floor heating, radiant system will affect heat conduction or result in the floor. In General, the flooring is better suited for geothermal floor, it is a high temperature pressing, internal moisture content less, so the floor against moisture loss and distortion.